Eastbourne Plumbers

If your hot and cold are backwards when you finish, turn the water back off, pull the cartridge back out, turn it over 180 degrees and re-install it.

Delta Style Valves

One other common design that is considered “washerless” was made famous by Delta and copied by several other makers. It uses little “cup” seals that fit over springs recessed in the back of the valve body. The springs press these “seals” against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it’s dripping, changing these springs and seals will usually correct it. Here’s a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don’t have long slender fingers.

Delta, and a few imitators, also have a faucet design that uses a ball instead of a cartridge. This is not as common in tub or shower valves but there are plenty of them out there. The springs and seals are the same but there are lots more o-rings an parts to deal with. The good news is that these parts are readily available. While it’s a little more complicated than learning how to repair a Moen kitchen faucet, which is a piece of cake, it is still easier than working with most washer type faucets.

These Techniques Work In The Kitchen Too

Armed with the knowledge you’ve gained in this article you now not only know how to repair a shower faucet and to repair a leaking tub faucet, but you can apply these skills to many other faucets as well. After fixing a leaky bathtub faucet, stopping a dripping outside hose faucet will be a breeze. The techniques that you will use to complete a “washerless” bathtub faucet repair can be used when repairing newer style water faucets of all kinds. Whether you have an old dripping tub faucet or a newer kitchen faucet that just won’t quite shut off you can now fix it. So put these new skills to use, roll up your sleeves and stop that drip!

Copyright 2008 Bryan Stevens

A leaking tap is one of the most common problems that we encounter in our households. Though most house problems call for a repairman’s help, there are some repairs that you could actually do on your own. In the case of a leaking tap, you don’t have to immediately call a plumber to fix this problem. Simply follow these steps on how to repair a leaking tap.

1. Turn off the water supply.

Before working on the leaking tap, you have to turn off the water supply first. Be careful when turning the valve off so that it won’t break apart.

2. Cover the sink hole.

To avoid your screws, washers and other small materials from falling down the drain, don’t forget to cover the sink hole prior to working.

3. Remove the top of the tap.

Using a screwdriver, unscrew the cover of the tap to expose the retaining screw. Remove this screw and put it in a safe place. eastbourne plumbers

Leave a Reply

Your email address will not be published. Required fields are marked *